Paver driveways
The biggest area on most properties and the one that fades first. Cleaned, re-sanded and sealed so tire marks and oil lift instead of soaking in.
Cleaned, re-sanded and sealed properly, so the color comes back and the weeds stay out. We measure on site and give you one written price.
Everything that gets sealed on a Cape Coral property, and the prep that has to happen first.
The biggest area on most properties and the one that fades first. Cleaned, re-sanded and sealed so tire marks and oil lift instead of soaking in.
Chlorine, sunscreen and standing water are hard on pavers. A matte or penetrating seal keeps the color without turning the deck into a skating rink.
Screened areas trap damp and grow mold in the joints. Sealing locks the sand down and makes the whole area far easier to rinse off.
Small areas that set the tone for the front of the house. Usually added to a driveway job for very little extra.
Every job starts here. Pressure clean, kill the mold and algae, then polymeric sand swept into every joint before a drop of sealer goes down.
Cloudy, flaking or peeling pavers need the old product taken off first. Quoted separately, because it is real work and nobody should hide it in a square-foot rate.
The sealer does the same job underneath. What changes is how the pavers look afterwards.
A penetrating sealer that soaks in and leaves the surface looking exactly as it does dry. Protection without a shine. The usual choice around pools.
A low sheen that brings the color back without gloss. The middle option, and the one most Cape Coral driveways end up with.
High gloss that darkens the paver and looks permanently just-rained-on. Dramatic on a driveway, too slippery for a pool deck.
Pavers here take more punishment than almost anywhere. Sealing is not a cosmetic add-on, it is what keeps the surface from losing a fight with the climate.
Polymeric sand locked in place stops weeds rooting and keeps the pavers from shifting under traffic.
Florida UV bleaches unsealed concrete pavers within a few seasons. A sealer holds the color instead of letting it wash out.
Oil, rust from irrigation water, sunscreen and leaf tannin sit on top of a sealed paver instead of soaking into it.
Our humidity grows black spotting and algae in the pores. Sealed pavers rinse clean rather than needing another pressure wash.
A hose and a stiff brush handles most of it once the surface is sealed, instead of hiring the pressure washer back.
Re-laying a paver driveway costs many times what keeping one sealed does. This is maintenance, not decoration.
On site, not over the phone. We check the paver type, the joints and whether anything has been sealed before, then put one figure in writing.
Pressure clean at the right pressure for the paver, plus treatment for mold, algae and the black spotting that comes back if you only wash it.
Polymeric sand swept in and set. This is what stops weeds and keeps the pavers locked together, and it is the step cheap quotes leave out.
Two coats in the finish you chose, applied when the pavers are properly dry and with an eye on the forecast. We walk it with you before we leave.
From gulf-access homes in the southwest to new builds up north, plus the neighbors across the bridges.
[CUSTOMER REVIEW]
[CUSTOMER REVIEW]
[CUSTOMER REVIEW]
Something else? Call (239) 329-7707 and ask.
Most Cape Coral jobs come out between $1.50 and $3.00 per square foot for a full clean, re-sand and seal. A typical driveway runs between $1,100 and $2,900, and a pool deck between $1,600 and $3,600. We measure on site before quoting.
Every two to three years for most Cape Coral properties. Full sun, afternoon storms and pool chemicals break a sealer down faster here than almost anywhere else, and a west-facing driveway goes first.
Foot traffic after about four hours in good weather, vehicles after 24 to 48. We time the job around the forecast, because rain inside the cure window is the one thing that ruins a seal.
Not if the right product goes down. Pool decks get a penetrating or matte sealer, with a slip-resistant additive where you want it. The high-gloss wet look belongs on a driveway, not around water.
Yes, and it is the most common call we get. Cloudiness means moisture trapped under a solvent sealer, usually from sealing damp pavers or over-applying. The old sealer has to be stripped before the new coat goes on.
Ranges are researched for Cape Coral and Lee County, not an offer. Your price comes from the free on-site measure and is given to you in writing. Full pricing breakdown.
We clean, re-sand and seal pavers. That is the whole business, which is why the sand gets swept in properly and the sealer goes down in the right weather rather than whenever the van is free.
Driveways, pool decks, lanais and walkways across Cape Coral and the rest of Lee County. Every quote is measured on site and written down before anything starts.
The crew is based right here in the Cape and has been sealing local pavers since 2019. Gum, tire marks and set-in stains get worked out before the sand goes in, and faded pavers can take a color-enhancing tint along with the seal.